Product Description
Pouch Board for all heated roll laminators
-
- New - Pouch Board made with MountCor Foam Board
- MountCor adheres to more type of papers and films
- MountCor's breathable surface reduces bowing and insures smooth results
- MountCor works at lower temperatures
- MountCor runs faster than standard heat activated boards
- 3/16inch thick foam board
- Standard Matte film with slight crystal texture finish
- Laminate hides fingerprints and has slight sheen
- Low temperature adhesives safe for all inkjet and other prints
- Run at 250 degrees and 2 feet per minute in roll laminators
- Edge seal on the 25 inch width
- Size: 25x37inch
- Color: White
- Quantity: 10
To use, lift up the laminate film and remove the MountCor Coversheet. Place your image on the board and roll down the laminate over your print. Set your laminator to the 3/16" thickness setting, 250 degrees, and process at 2 feet per minute. If you want to run faster, increase the temperature approximately 10 degrees for each foot per minute you increase the speed.